Material: 30 mil Polycarbonate Plastic
Size: Approx. 7.5" x 7.5"
Made in the USA
Please Note: For sanitary reasons, all approved orders of The Phoropter Shield™ are non-returnable. For international customers, as well as customers in Alaska, Hawaii and Puerto Rico, please note that your orders will not be considered "approved" until you have approved the shipping charges, which will be sent to you in a quote.
Cleaning Instructions:
Using warm water with soap, thoroughly wash away any debris. It is recommended to use a lint-free cloth with alcohol, or another disinfecting wipe, to sterilize the plastic between uses. In order to avoid scratching the plastic, please do not use any abrasive cleaning products, such as brushes.
Installation Instructions:
To install the Phoropter Shield™ onto a standard manual phoropter, begin by removing the plastic protective film on both sides of the device. Next, with the phoropter in normal position, place the wings of the phoropter shield so that they come to rest on the joint which holds the JCC/Cross Cylinder prisms on each side. The unit should come to rest on this joint and allow for the JCC/Cross lenses to be adjusted with the shield in place. It is possible that the shield may move slightly when these lenses are adjusted, depending on the phoropter model. If so, please move the shield back into place after adjusting. Refer to the video on the "Video" section of the product page for a quick demonstration of the installation and removal.
Legal Disclaimer:This item has not been reviewed or approved by the FDA and was not designed to treat or cure any disease. Bernell recommends that users of the Phoropter Shield™ comply with the current American Academy of Ophthalmology, Center for Disease Control, and World Health Organization Coronavirus Guidelines, in conjunction with the use of the Phoropter Shield™ for examination of patients during the Coronavirus pandemic. Bernell Corporation, does not guarantee or warranty protection from any virus, bacteria, or any other communicable disease, mold, or chemical inhalation by or through the use or wear of the breath shield. Bernell makes no scientific or legal claim regarding its effectiveness for any particular or intended purposes, including, without limitation, safety, reliability, durability, and performance. The user or wearer of the Phoropter Shield™ assumes any and all risk of illness or injury caused by such use or wear.
Material: 30 mil Polycarbonate Plastic
Size: Approx. 7.5" x 7.5"
Made in the USA
Disclaimer: Please note that the products offered on our website have not been evaluated or reviewed by the United States Food and Drug Administration (FDA), unless explicitly stated otherwise. The information provided on this website is for informational purposes only and is not intended to diagnose, treat, cure, or prevent any disease or medical condition. The products offered on our website are not intended to replace or substitute any advice, diagnosis, or treatment provided by a qualified healthcare professional. It is strongly encouraged that any use of our products in an effort to improve visual skills only be done so under the guidance and supervision of a qualified healthcare professional.
